Whats the purpose of maintaining ABA blown film machine?

Co extrusion ABA film blowing machine, whether it is the production of HDPE materials or LDPE and LLDPE materials, has its unique characteristics. The physical strength of the film is improved by multi-layer co extrusion, and a host machine is used for feeding material inside and outside, so that the configuration of a main machine can be reduced, and the purpose of reducing cost, energy saving and low consumption can be achieved.

Film blowing machine in the processing process to get quality control of plastic bag products, it is necessary to control the processing link in place. Under normal circumstances, the processing of film blowing machine is divided into feeding heating, traction, control the compressor edge. After the film head blows the air, the gas is added to the middle of the round film, the film is made up in a straight line, the size of the plastic bag is controlled by the blowing amount, and then the film stabilizing device is used to stabilize the membrane.

The thickness of the main traction speed control, this can be understood, the engine speed faster, feeding speed is fast, the film thickness, the traction is just the opposite, pull faster, traction rotating film blowing machine, film is thin, this is the main part of the.

In the film blowing machine feeding section entrance, to a lower temperature, prevent the resin viscous flow inlet is blocked, in addition, continuous feeding in the compressed air to pour Duan Shuzhi, discharged from the feed port. According to the structure of film blowing machine, the price of high quality film blowing machine, although the feeding port is not electrically heated, the operation steps of the blowing machine, but the heat transfer through the barrel, the feed temperature of about 50-90 degrees. In this way, the temperature of the feed section is determined.

Film blowing machine in the processing process to get quality control of plastic bag products, it is necessary to control the processing link in place. Under normal circumstances, the processing of film blowing machine is divided into feeding heating, traction, control the compressor edge. After the film head blows the air, the gas is added to the middle of the round film, the film is made up in a straight line, the size of the plastic bag is controlled by the blowing amount, and then the film stabilizing device is used to stabilize the membrane. The thickness of the main traction speed control, this can be understood, the engine speed faster, feeding speed is fast, the film thickness, the traction is just the opposite, pull more quickly, the more thin film, which is a most important link.