
PE film blowing machine mechanical processing technology tips
Tip 1:
Will vice jaw to take off and the other two M4 threaded hole processing, will be two pieces and jaw level 2, 1.5 mm thick steel plate with aluminum countersunk rivet rivet on the 0.8 mm thick hard brass plate 3 to use the M4 countersunk screw fastening to the jaw, 1 form durable soft jaw. It also can protect the parts is bad, but also are interchangeable.
Tip 2:
With magnet absorb small parts (fee) isn't very convenient for suction and draw
In the magnets 1 suck a sizzling 2 below
Not only can absorb a lot of small pieces
And the iron plate away small immediately pour into the collection box automatically
Not enough to move the heart But it's very practical
Tip 3:
When the pulley drive Slippage between pulley and shaft often
On the shaft with ¢15 to 18 mm draw a series of litter bit of litter
So that we can form adsorbability To prevent the skid
The boss will reward waste
Tip 4:
When Allen wrench handle 1 short, can't focus on the inner diameter can be slightly larger than the wrench pipe from a groove
Insert the wrench groove, but as a long handle.
Tip 5:
For tightening the workpiece what does that mean: first positioning and clamping, but? , I think for a workpiece clamping and positioning, first because when clamping affirmation to the workpiece deformation, therefore, should be first clamping and positioning, for 6 point positioning, seek to limit its freedom.